TM
Model 3000M0188-01
Rev. 5/16 7-27
Lubrication and Maintenance
Before storing planter, disengage granular chemical drive by
rotating throwout knob ¼ turn counterclockwise. Remove drive
chain and empty and clean all granular chemical hoppers.
Clean drive chains and coat them with a rust preventive spray
or submerge chains in oil. Inspect and replace worn or broken
parts.
Install hoppers and chains. Check chain alignment.
Before storing planter, inspect each spring tooth incorporator
and replace worn or broken parts. Check for loose hardware
and tighten as needed.
Disengage
Engage
GRANULAR CHEMICAL ATTACHMENT
SPRING TOOTH INCORPORATOR
SPIKED CLOSING WHEEL
Inner parts of spiked closing wheel will begin to wear at
approximately 70% of life. Flip/reverse wheel to utilize
remaining life of wheel.
Row Unit Spiked Closing Wheel
To Next Page
Loading...
