M0188-01Model 3000
TM
Machine Operation
2-16
Rev. 1/14
RIDGE PLANTING
2. Mount contact drive wheel arm and springs to lower
set of mounting holes in wheel module mount.
3. Raise hitch height to keep planter level front and rear.
New axle location.
PLANTING SPEED
Planters are designed to operate within a speed range of 2 to 8 mph (3.2 - 12.8 kph). See “Rate Charts”. Variations in
ground speed produce variations in rates. Finger pickup seed meter populations tend to be disproportionately higher at
high ground speeds.
NOTE: Seed spacing can be adversely affected at speeds above 5.5 mph (8.8 kph).
Planter toolbar height can be raised 3" (8 cm) for ridge planting.
1. Relocate 20" transport axles to lower rear holes in
ground drive wheel arm.
Move contact drive
wheel arm here.
Move springs here.
Transport axle
Wheel module mount
To Next Page
Loading...
