6-3
TROUBLESHOOTING CHART
PROBLEM
SOLUTION
Oven will not operate. Electronic oven control is not set prop-
erly.
A delay start has been programmed.
Reset the oven control (see the Use &
Care Guide for instructions describ-
ing the function you are operating).
Range is not plugged in.
A household fuse or circuit breaker
has opened.
Burner ports are clogged.
Burner fails to light.
Burner flames are uneven. Burner ports are clogged. Clean burner ports with straight pin.
POSSIBLE CAUSE
Wait for the start time to be reached.
Plug power cord into a live AC outlet.
Replace fuse or reset the breaker.
Clean burner ports with straight pin.
Burner flames lift off ports, are yel-
low, or are noisy when turned off.
Adjust air shutters for bake or broil
burners.
Top burner ports are clogged. Clean
or replace burner.
The air-to-gas mixture is incorrect.
Burner is wet.Burner makes “popping” noise when
on.
It is normal for all four burners to
spark briefly when:
• A draft is blowing on the burners.
• A very large pot on burner causes
flame to be unstable.
• The burner is turned on but has not
ignited.
Continuous sparking may be caused
when:
• A switch contact is wet.
• There is a faulty spark module.
• The wall outlet wiring is not
correct.
Burners spark.
Allow burner to dry.
Allow switch to dry.
Replace the spark module.
Rewire wall outlet.
To Next Page
Loading...
