5
For disassembly and reassembly, prepare the following tools.
No. Tool name Application Icon
1
Wrench
10mm / 13mm / 17mm / 19mm
Bolts and nuts
2
Hexagon wrench
4mm / 5mm / 6mm / 8mm / 10mm
Socket bolts
3 Snap ring pliers S (Large) (Small) Snap rings (shaft)
4 Snap ring pliers R Snap rings (hole)
5 Socket wrench 10mm Bottom yokes
6 Combination pliers Split pins
7 Adjustable wrench
8 Plastic hammer
9 Screwdrivers (+)(-)
10 Puller Bearing, fan, brake, hub
11 Thickness gauge
12 Torque wrench/nut runner
13 Plier Set pin
●
Use the following types of grease.
• JIS K2220 Grease type 1 No.2 for Roller shaft bearing
• Molybdenum disulfide lubricant Molytherm No.2 (Specified brand: SUMICO LUBRICANT)
●
Helpful tools
• Remover: Prepare a remover for bearings (for inner race & outer race) and one for oil seal for precise operation.
• Preparing two wooden blocks (used as sleepers) and wire for guiding lead wires will be helpful.
Disassembly and assembly tools
Disassembly and assembly tools
Torque
To Next Page
Loading...
Need help?
General
