KITO ER2M Disassembly And Reassembly Guide

31
Connecting the motor and body
3
(1) Install the 2 set pins and Packing M to the
motor.
(2) Mount the body on the motor.
•
Mount it so that the Chain Guide A side of the body is in
the name plate side of the motor.
•
Be careful so that the lead wire won't get caught between
the body and stator.
•
Fit the spline hole at the pinion bottom to the spline shaft
at the motor shaft tip by rotating the pinion.
•
Hammer the motor gently with a plastic hammer to
connect the motor without any gap.
•
Apply screw lock on the 4 socket bolts, and install the
motor and body.
Tightening torque M6 : 10.8 N·m
M8 : 34.3 N·m
M10 : 39.2 N·m
M12 : 58.8 N·m
(3) Install the limit lever to Chain Guide A at the
body bottom.
•
Fit the limit lever to Chain Guide A, insert the lever pin with
the limit lever spring installed, and align it with the hole
position of Chain Guide A to install it.
Limit lever
pin
Lead wire
Limit lever
spring
Limit lever
Pass the
lead wire.
Packing M
Chain Guide A
Stator
Body
Socket bolts (x4)
Name plate
Set pin
(Push in another one in the
opposite side, on a diagonal line.)
NEW
Torque
Lock
Pass through the
wiring hole of the body.
Reassembly procedure
(To be continued)
Connecting the motor and body

KITO ER2M Specifications

General

Brand	KITO
Model	ER2M
Category	Chain Hoists
Language	English