Kiwi Technics Patch Editor - Organix Midi 3 P Upgrade

12
SYNTH TABLES
Organix Midi 3P Upgrade
Cable requirements
The Organix midi 3P Upgrade uses a standard MIDI cable
PE release v4.6 or higher.
Organix JX-3P Controls
Osc 1 Range (1) 16', 8', 4' LFO Wave (26) Triangle, Square, Random
Osc 1 Wave (2) Sawtooth, Pulse, Square LFO Delay (27) Active
Osc 1 PW (3) Not Used LFO Speed (28) Active
Osc 1 Tune (4) Not Used Chorus/FX Rate (29) Not Used
Osc 1 LFO Mod (5) Not Used Chorus/FX Mode (30) Chorus On, Chorus Off
Osc 1 ENV Mod (6) Not Used HPF (31) Off, 10% to 100% - For continuous control
use (17)
Osc 1 Mode (7) Used to enable Osc 1 LFO & Env modulation LPF Cutoff (32) Active
Osc 1 PWM (8) Not Used LPF Resonance (33) Active
Osc 1 Level (9) Osc 1 & 2 Mix Filter LFO Modulation (34) Active
Noise Level (10) Not Used Filter ENV Modulation (35) Active
Osc 2 Range (15) 16', 8', 4' Filter Key Follow (36) Active
Osc 2 Wave (16) Sawtooth, Pulse, Square, Noise Filter ADSR (37-40) Not Used
Osc 2 PW (17) HPF Continuous control Filter Mode (41) EG Normal, EG Inv
Osc 2 Tune (18) Active VCA ADSR (42-45) Active
Osc 2 Fine Tune (19) Active VCA Mode (46) Envelope, Gate
Osc 2 LFO Mod (20) Not Used VCA Level (47) Active
Osc 2 ENV Mod (21) Not Used
Osc 2 Mode (22) Used to enable Osc 2 LFO & Env modulation
Osc 2 PWM (23) Not Used
Osc 2 XMod Sync Off, Sync On, Metal
Osc 2 Level (25) Not Used
www.kiwitechnics.com Patch Editor v6.0