Kiwi Technics Patch Editor - Synth Tables; Fender Chroma Polaris

7
SYNTH TABLES
Fender Chroma Polaris
Cable requirements
The Fender Chroma Polaris uses a standard MIDI cable
PE release v5.0 or higher.
Fender Chroma Polaris Controls
Osc 1 Range (1) Not Used LFO Wave (26) Sweep Wave - Sine, Square
Osc 1 Wave (2) Saw, Pulse LFO Delay (27) Vibrato Delay
Osc 1 PW (3) Osc 1 Pulse Width LFO Speed (28) Sweep Rate
Osc 1 Tune (4) Osc 1 Transpose Chorus/FX Rate (29) Glide Rate
Osc 1 LFO Mod (5) Osc 1 Vibrato Amount Chorus/FX Mode (30) Not Used
Osc 1 ENV Mod (6) Not Used HPF (31) Noise Source - Off, On
Osc 1 Mode (7) PWM Source - Env, Sweep LPF Cutoff (32) Active
Osc 1 PWM (8) Osc 1 PWM LPF Resonance (33) Active
Osc 1 Level (9) Not Used Filter LFO Modulation (34) VCF LFO Sweep Depth
Noise Level (10) Not Used Filter ENV Modulation (35) VCF Env Depth
Osc 2 Range (15) Not Used Filter Key Follow (36) VCF Key Track
Osc 2 Wave (16) Saw, Pulse Filter ADSR (37-40) VCF Envelope
Osc 2 PW (17) Osc 2 Pulse Width Filter Mode (41) VCF ENV Mode - Fixed, Touch
Osc 2 Tune (18) Osc 2 Transpose VCA ADSR (42-45) VCA Envelope (no sustain)
Osc 2 Fine Tune (19) Osc 2 Detune VCA Mode (46) VCA ENV Mode - Fixed, Touch
Osc 2 LFO Mod (20) Osc 2 Vibrato Amount VCA Level (47) Active
Osc 2 ENV Mod (21) Osc 2 Env Amount
Osc 2 Mode (22) PWM Source - Env, Sweep
Osc 2 PWM (23) Osc 2 PWM
Osc 2 XMod Sync / Ring Mod - Off/Off, On/Off, Off/On, On/On
Osc 2 Level (25) Not Used
www.kiwitechnics.com Patch Editor v6.0