KMT SL-IV PLUS Series - Worldwide Product Support; Main Menu and Screen Navigation; HP Cylinder Assembly Procedures; Motor;Hydraulic Service Maintenance

05149257
SECTION 5 TROUBLESHOOTING
5 Troubleshooting
5.1 Troubleshooting - Electrical 5-1
5.1.1 Pump Will Not Start 5-1
5.1.2 Console Display And Lights Fail To Illuminate 5-1
5.1.3 Pump Quit Running 5-1
5.1.4 No Control Power (24vdc) 5-2
5.1.5 Red Light, Message On Operator’s Console 5-2
5.2 Troubleshooting – Hp Water 5-3
5.2.1 Hp Water Signal Abnormal Fluctuation 5-3
5.2.2 Hot Surfaces On Hp Cylinder Components 5-3
5.2.3 Oil Or Water Leaks From HP Cylinder Weep Holes 5-3
5.2.4 Hp Check Valve Leak 5-4
5.2.5 Normal Temperature, But Check Valve Problem 5-4
5.2.6 Hp Cutting Water Too Low 5-4
5.3 Troubleshooting – Lp Water 5-5
5.3.1 Low Booster Pump Pressure 5-5
5.4 Troubleshooting – Hydraulic 5-5
5.4.1 Hot Hydraulic Oil 5-5
5.4.2 Hydraulic Pressure But No High Pressure Water Pressure 5-5
5.5 Special Procedure—Hp Water Check Valve 5-7
5.5.1 Hp Check Valve Troubleshooting 5-7
SECTION 6 LOW PRESSURE WATER SYSTEM
6 Low Pressure Water System 6-1
6.1 Oil Cooling Water Supply 6-1
6.2 Cutting Water Supply 6-1
6.2.1 Normal Operating Condition 6-2
6.2.2 Operation 6-2
6.2.3 Boost Pump Pressure Adjustment 6-6
6.2.4 Low Pressure System Protection 6-6
6.3 Maintenance Overview 6-7
6.3.1 Water Filter Service 6-7
6.3.2 Boost Pump 6-8
SECTION 7 HIGH PRESSURE WATER SYSTEM
7 High Pressure (HP) Water 7-1
7.1 Components 7-1
7.2 Intensifier Disassembly and Reassembly 7-2
7.2.1 HP & LP Water Piping 7-3
7.2.2 HP Cylinder “Jug” (HP Cyl., Sealing Head, Flanges, & Studs 7-4
7.2.3 Stud Nuts and End Flange, Sealing Head 7-5
7.2.4 HP Plunger Seal Service-- Disassembly / Re-assembly 7-6
7.2.5 Plunger and Hydraulic Cartridge Removal and Installation 7-10
7.2.6 Hydraulic Cylinder Head & Hydraulic Piston 7-11
7.3 Intensifier Subassemblies Inspection & Repair 7-13
7.3.1 Discharge HP Check Valve 7-14
7.3.2 Inlet Check Valve 7-16
7.3.3 Sealing Head 7-18
7.3.4 HP Cylinder 7-19