Fitting the Covers
KODAK 9000C and KODAK 9000C 3D Extraoral Imaging System Installation Guide (SM714)_Ed 01 5–23
2. Switch ON the unit. To fit the protection plates (D) and (E), press and hold to
position the rotative arm so that from above the unit head, you can see the 3 screw holes
on each side of the rotation axe.
3. Switch OFF the unit. From below the unit head, slide the protection plate (D) between
the rotation axe and the unit head.
From above the unit head, access and tighten the accessible fixing screws. Switch ON the
unit. Press and hold to position the rotative arm so that you can access the
inaccessible fixing screw. Switch OFF the unit. Access and tighten the fixing screw.
IMPORTANT
Make sure that you slide the protection plate side with the
indention for the fixing screws towards the top.
2.5 mm
E
3x
M4x8
D
3x
M4x8
To Next Page
Loading...
