TP-6322 9/0438 Section 6 Service Part Replacement
6.6.2 Other Service Part Installation
1. Position the part(s) in place in the same manner
that the old part was installed. Support the back of
circuit boards when installing plug-in parts, such as
relays, to avoid bending the circuit board.
2. Tighten or reinstall hardware that holds the part(s)
in place to the general torque specifications in the
appendix unless otherwise noted.
3. Reconnect wiring to the same locations from which
they where removed, torquing terminals to the
specifications given in the maintenance section of
this manual.
4. Follow the instructions under After Service in
Section 6.1.
To Next Page
Loading...
Need help?
General
