Kohler KBS - Default Chapter; Table of Contents

Table of Contents
TP-6835 9/17 Table of Contents 3
Safety Precautions and Instructions 5.........................................................
Introduction 7...............................................................................
List of Related Materials 7......................................................
Service Assistance 8.........................................................................
Section 1 Product Description 9..............................................................
1.1 Purpose 9..............................................................
1.2 Nameplate 9............................................................
1.3 Model Designation 10.....................................................
Section 2 Installation 11......................................................................
2.1 Introduction 11...........................................................
2.2 Receipt of Unit 11........................................................
2.2.1 Inspection 11....................................................
2.2.2 Lifting 11........................................................
2.2.3 Storage 12......................................................
2.2.4 Unpacking 12....................................................
2.3 Installation 13............................................................
2.4 IBC Seismic Certification or California OSHPD Approval 14....................
2.5 Manual Operation Check 15...............................................
2.5.1 Manual Operation, 150--4000 Amp Standard-Transition Model KBS 16..
2.5.2 Manual Operation, 150--4000 Amp Programmed- and Closed-
Transition Models KBP and KBC 17.................................
2.6 Controller Connections 18.................................................
2.6.1 Controller Input and Output Connections 19..........................
2.6.2 Harness Connection 19...........................................
2.6.3 Controller Ground 19..............................................
2.7 Electrical Wiring 20.......................................................
2.7.1 Source and Load Connections 20...................................
2.7.2 Extended Transfer Time Relay (Model KBC only) 22..................
2.7.3 Engine Start Connection 24........................................
2.7.4 Auxiliary Contacts 25.............................................
2.8 Communication and Accessory Connections 25..............................
2.9 Functional Tests 25.......................................................
Section 3 Three-Source Systems 27...........................................................
3.1 Three-Source Systems 27.................................................
3.2 Three Source Engine Start Mode 27........................................
3.2.1 Mode 1 27.......................................................
3.2.2 Mode 2 27.......................................................
3.3 Preferred Source Toggle 27................................................
3.4 Three Source System Test and Exercise 27..................................
3.4.1 Unloaded Test 27.................................................
3.4.2 Loaded Test 27...................................................
3.4.3 Unloaded Exercise 27.............................................
3.4.4 Loaded Exercise 27...............................................
3.5 Three-Source System Connection 28.......................................
3.6 ATS1 and ATS2 System Setup 30..........................................
Section 4 Communication and Accessory Connections 31......................................
4.1 Introduction 31
...........................................................
4.2 Communication Connections 31............................................
4.2.1 USB Port SiteTech Connection 31..................................
4.2.2 Modbus Connection 31............................................
4.2.3 Ethernet Connection 33...........................................