6.6 Alternator belt replacement
1 -
Loosen capscrews A and remove guard B.
2 -
Loosen hollow stud C and capscrew D.
3 -
Remove the belt F.
4 -
Perform the operations from point 2 to 6 of Par. 6.7.
5 -
Insert the new belt F on
pulleys G.
6 -
Move alternator E in
the direction of arrow
H, tighten capscrew D
followed by hollow stud
C (tightening torque at 40
Nm).
7 -
Check the tension of belt
F with a Clavis-type of
instrument, positioning it
in point P (the value must
be 392 N).
8 -
Secure guard B with capscrews A (tightening torque at 5
Nm).