K20s
computer, connect handheld to computer with a cable, and install EGStar into the handheld, at
the same time, keep the mainframe power on, then set as follows:
Open EGStar software and enter the main interface. Click “OK” on the "prompt" window.
2. Go to “Bluetooth Manager”, in this interface tap on “Search” button and the controller will
search the surrounding Bluetooth devices, select the correct serial number from the list and click
on “Connect” button, controller will connect to receiver without setting any COM port. If the
prompt message “Bluetooth connect success” appears, that means that controller has
successfully connected with receiver, then please check the Bluetooth indicator on receiver.
Please go to this website
https://1drv.ms/b/s!Ati6xekUm6DXgxEjcOJ7H_mMCCY6?e=ho8AAK
for more information if using Android EGstar.
To Next Page
Loading...
