Name: Kolida K20s
Brand: Kolida
Rating: 4 (1 reviews)

To Next Page

To Previous Page

K20s

- 80 -

2) Install the receiving antenna onto the rover receiver, and screw the receiver into the carbon

fiber pole, then power on the receiver.

3) Set the receiver as rover with internal radio mode. (set on the control panel, or on internal

Web UI or on the software installed on data collector).

§6.2.1.4 Rover settings

Using EGStar3.0

1) Run EGStar3.0 program on data collector;

2) Go to “Config—Device Config—Instrument Config” page to configure the working mode

and datalink for rover receiver.

3) Tap on “Work mode setting” and then check the box of “Set work mode”, then click on

“Next” to continue;

4) Check the box of “Rover” option and click “OK” and return to Instrument setting page. At

this moment, KOLIDA K20s prompts the correct working mode with voice guide.

Rover receiver

UHF receiving antenna

Questions and Answers:

Need help?

Do you have a question about the Kolida K20s and is the answer not in the manual?

Kolida K20s Specifications

General