Konica Minolta CA-310 - Installation;Connection; About Installation; About Connection; Power ON;OFF Procedure

21
Installation/Connection
<Out of Measurement Range>
[For xylv, T
∆∆
∆∆
∆uvLv, u'v'Lv or XYZ,Analyzer Mode]
● When the measurement range is exceeded Digital display : “– – – – –”
Analog display : Not lit
LCD display : “OVER”
[For T
∆∆
∆∆
∆uvLv Mode]
● T or ∆uv are out of Digital display : “– – – – –”
the display range (T and ∆uv)
[For Flicker Mode**]
● When the measured value has Digital display : “– – – – –”
exceeded 999.9% Analog display : Not lit
LCD display : “FLICKER ERROR OVER”
● When Lv(luminance) is the following Digital display : “– – – – –”
under 0.1cd/m
2
for LED Flicker Measuring ø27 Probe Analog display : Not lit
(CA-P32/35)
LCD display :
“
FLICKER ERROR UNDER ”
under 0.3cd/m
2
for LED Flicker Measuring ø10 Probe
(CA-PS32/35)
**Flicker Mode is a function which can be used only when LED Flicker Measuring ø27 Probe(CA-P32/35) or LED Flicker Measuring ø10
Probe(CA-PS32/35) is connected.