KORG D12 Guided Tour
15
12. Repeatedly press ENTER, until the space just to the right of “WAIT_” is highlighted, then u to the “0..9” button.
13. Press ENTER, then rotate the [DIAL] until the highlighted space indicates “2”, and then u to the “OK” button.
14. Press ENTER to rename the copied song “I CAN’T WAIT2” and return to the “SelSong” page.
15. The [TRACK STATUS] LED's below the display should all be lit green. If not, press any of the [TRACK STATUS] keys so that
they all light green (Play status).
Disable Scene Memory and work with the MixView display:
1. Press [SCENE] (lit) until you select the “ReadDel” tab, then u to the “SceneRead:On” button and press ENTER, so that the
stored scene for this demo song is disabled. It’s important that “SceneRead:Off” is indicated in the display for the following
steps!
2. Press [SCENE] until you select the “MixView” tab, then press [PLAY] to begin playback.
3. Raise the CHANNEL faders and MASTER fader to create an initial mix of the demo song:
Note: Use the Track Layout on page 4 of this guide as your mix reference.
You can accurately set the faders and pan/balance knobs to the same settings as the stored scene by referencing the “MixView”
display. Move each of the faders and pan/balance knobs, and as you do this, watch the upper-left of the display. The original values
of level and pan placement for each channel will be indicated when two arrows appear to the right of the fader or pan parameter:
View the Post Fader levels as you mix:
4. As the song plays, press [METER/TRACK VIEW], and make sure that the upper-left popup button is set to “PostFdr”, so that
you can view the track levels as you mix. If it is not, press ENTER and u to “PostFaderLev”, press ENTER again, then u to
“OK” and press ENTER. Be careful not to set Channel and Master fader levels so that the meters reach the “CLP” line in the
display.
Mute / Un-mute tracks with the TRACK STATUS keys:
5. While the song continues, try muting and un-muting tracks, by pressing the [TRACK STATUS] keys (unlit: mute / green: play).
6. Mute all tracks except tracks 4, 5, 6, and 7/8 (Bass, Kick, Snare, Drums and Percussion L/R).
Note: Use the Track Layout on page 4 of this guide as your mix reference
Tip: To reset the demo song to the beginning when stopped or during playback, press [IN/LOC1].
To Next Page
Loading...
Need help?
General
