KORG D12 Guided Tour
17
1in1outx4:
The default setting for new songs. Good to use for fixed panning sources like rhythm guitar - selecting this configuration lets you
select from four mono Insert effects to be used in the song.
1in1outx8:
The largest configuration of multiple effect choices - use this one when you need up to eight mono effects in a song. Ideal for fixed
pan sources that need effect isolation, like drums.
Note: For more information on setting assignments, configurations and locations of insert effects see the D12 Owner’s
Manual, pages 43 and 105.
Work with the lead vocal track in “I CAN’T WAIT”:
1. Press the Channel 1 [TRACK STATUS] key so that it lights green (un-muted). Tracks 4, 5, 6, 7/8 should also be un-muted
([TRACK STATUS] keys lit green).
Set a new Locate Point in the song:
2. Press [IN/LOC1] to reset the song to the beginning. The display should still be on the INSERT EFFECT page.
3. u to highlight the “000:00.000” position in the “Counter”, and use the [DIAL] to set it to “000:13.000” (13 seconds).
4. Press [STORE] and then press [OUT/LOC2], to set an “on-the-fly” locate point for you to use as you go through the following
steps and audition new insert effects for the lead vocal track.
5. Press [PLAY] to resume playback from this point.
Note: The default setting for all four locate keys is at the beginning of each new song.
Also Note: Waveform viewed Locate points can be stored by using the SCRUB function, for setting even more precise locations.
More on this in the following exercises:
Work with the lead vocal (Track 1) Insert effect:
6. As the song continues, press [OUT/LOC2], and then press [INSERT EFFECT] until you select the “InsEff1” tab (. As you
audition effects while the song plays, press [OUT/LOC2] whenever you like, to reset to the stored locate point and continue
playback.
7. Make sure that the effect number “I105”, to the left of the effect name button is highlighted. This is a microphone
modeling/limiter chain, assigned to the lead vocal track.
8. Slowly rotate the [DIAL] left or right, to select and listen to new insert effects. Note that you’ll find additional mic modeling
effects in locations “I101-108”.
9. Rotate the [DIAL] until you recall effect “I105”, then u to highlight the “MM33:MicSM57/414” button, followed by pressing
ENTER.
10. u to each of the “MicSim” and “Limiter” effect “icons”, then press ENTER to view, select and adjust a few parameters for
these effects.
To Next Page
Loading...
Need help?
General
