KORG D12 Guided Tour
16
Work with the EQ function:
1. As the song plays, press [EQ/PHASE] until you select the “Eq1-4” tab.
2. u to highlight different EQ "knob” icons in the display, and the upper-left corner of the display will indicate the EQ parameter
and track you are working with.
3. u to the “HiEq” knob for track 1 - the display will indicate “HiEq1”.
4. Rotate the [DIAL] to apply new High EQ settings to the lead vocal track.
5. u to the “MidEq1” knob icon, and use the [DIAL] to apply Mid EQ settings.
6. u to the “MidFc1” knob, and use the [DIAL] to set a new Mid frequency for the lead vocal track, and then work with the
“LoEQ1” values to finish working with the track.
View the Insert effect Assignments for the demo song:
1. Press [STOP], and then press [IN/LOC1] to reset the song to the beginning.
2. Press [INSERT EFFECT] until you select the “InsAss” tab. The diagram below indicates the settings for this song:
3. u to the
>
> popup button to the right of “Assign:” in the upper-left of the display, then press ENTER.
4. Make sure that the “PlayTrack” radio button is selected (you'll be applying an insert effect to a playback track). Press ENTER
to return to the previous page.
5. In the display, note the Insert effect track locations for playback: Track 1>Insert effect [1], Track 5> Insert effect [2], Track 7>
Insert effect [3], Track 8> Insert effect [4]. The effect configuration is set to use four insert effects on playback.
Overview of D12 Insert effect Configurations:
There are four configurations available in the Select Effect Type menu:
1in2outx2:
Primarily Guitar and Bass Chains of 3-5 effects each, Use for recording / on input only. This configuration is good for mono-in,
stereo-out sources.
2in2outx2:
Great selection of effects for keyboards and stereo output instruments.
To Next Page
Loading...
Need help?
General
