KORG D12 Guided Tour
21
You'll continue to use the currently selected song for the following exercises…
View the current Master effects and send levels:
1. Press [MASTER EFFECT/AUX] until you select the “MstEff1” -note that “M002 RV2:SmoothHall” has been assigned. View
the “RetLev” (return level) and “RetBal” (return balance) settings in the display:u to each “knob” icon: the value is then
displayed in the upper left corner.
2. Press [MASTER EFFECT/AUX] until you select the “EffSnd1” tab, then view the send level "knob" icons for each track.
3. Press [MASTER EFFECT/AUX] until you select the “MstEff2” tab (“M004 RV4: Dry Plate” has been assigned), and then
press [MASTER EFFECT/AUX] until you select the “EffSnd2” tab, and view the send levels.
Set new Master effect send levels:
4. With playback STOPPED, hold [STOP] and press [REW] (or press [END/LOC4]) to reset the song to the beginning (this locate
key is currently set to locate to the beginning of the song).
5. Press [PLAY], and make sure that the Channel faders are raised, and the [TRACK STATUS] keys are all lit green (Play
status).
6. Press [MASTER EFFECT/AUX] until you select the “EffSnd1” tab, and as the song plays, u to select the “knob” icons, and
rotate the [DIAL] to set new send levels for desired tracks to Master effect 1. Note: Refer to the Track Layout on page 4, and
remember that the upper-left of the display indicates the selected track and send value.
7. Press [MASTER EFFECT/AUX] until you select the “EffSnd2” tab, and set new send levels for desired tracks into Master
effect 2.
Tip: To reset the demo song to the beginning during playback, press [END/LOC4].
8. When you’ve finished setting new send levels, press [STOP].
Note: Channel Pairing of send levels, EQ, Track Status and more is available for adjacent (odd/even) channels. For more
information, see the D12 Owner’s Manual, page 38.
Work with the Final effect:
The Final effect is an independent processor with 32 preset and 32 user Final effect programs available. It is located at the end of the
effect routing scheme in the D12, and is used for "mastering" and dynamics applications. During mixdown you can use a Final effect
to "polish" your mix as you master your work to external DAT, MD, etc. The assigned Final effect will also be “printed” to tracks
(including Virtual tracks) during bounce recording operations. Note: Like the Master effects, the demo song includes an already
assigned Final effect.
To Next Page
Loading...
Need help?
General
