Changing the auto power-off setting
Changing the settings in the start-up dialog box
If the auto power-off function is enabled so that the power will turn off automatically, the currently specified auto
power-off time is displayed immediately after the system starts up.
1. While this message is shown, press the Change Setting button in the dialog box.
The following dialog box will appear.
2. Press the popup button and select the desired time for auto power-off to occur. If you don’t want the power to turn
off automatically, choose Disabled.
Note: If this dialog box does not appear immediately after start-up, the auto power-off function is set to Disabled; the
power will not turn off automatically. Note: You can also change the auto power-off setting during operation (see page
16 of the Operation Guide).
Auto power-off warning message
When the specified time has elapsed, a message will warn you that the auto power-off function is about to turn off the
power.
If you want to continue using the KROME, press the keyboard, a button, or the display. Auto power-off will be reset,
and the same message will appear when the specified time has again elapsed without any user input.
About the display and the modes
Display
The KROME uses Korg’s TouchView graphical user interface.
By pressing or dragging objects shown in the display, you can select programs or combinations, or edit parameter
values. Here we’ll explain the names and functions of these objects.
To Next Page
Loading...
