Sampling (Open Sampling System)
130
Making settings for the sample to be
recorded
(REC Sample Setup/Sampling Setup)
Next we will specify the location into which the data will be
sampled, select mono or stereo sampling, and specify the
sampling time.
In SAMPLING mode, these settings are made in REC
Sample Setup. In COMBINATION, PROGRAM, and
SEQUENCER modes, these settings are made in Sampling
Setup. These settings apply only in each respective mode.
The Recording Setup page in each mode
SAMPLING mode
PROGRAM mode
Save to
Specifies the destination to which the data will be written
during sampling.
RAM:
The sample will be written to RAM memory.
Samples written into RAM memory can be heard
immediately in SAMPLING mode.
Disk:
The sound will be recorded to internal drive as a
WAVE file. You can select a drive, directory, and file name
for the recorded file using the
Select Directory/File for
Sample to Disk
menu command.
Use
Drive Select
to select the desired drive, which can be
either an internal disk or a USB storage device. Then, use the
Open
or
Up
buttons to move to the desired folder level, and
use the
Name
parameter at the top of the window to specify
a name for the sample file. Press the
Done
button to confirm
the settings you’ve made.
While this dialog is open, you can also audition the selected
WAVE file by pressing the on-screen
Play
button or the
front-panel
SAMPLING START/STOP
button. To stop
playback, either press the
SAMPLING START/STOP
button again, or touch the on-screen Stop button.
Mode
Specifies the channel(s) that you want to sample, and specify
whether a mono or stereo sample will be created.
The L and R channels of the bus specified by
Source Bus
will be sampled.
L-Mono:
The L channel of the bus specified by
Source Bus
will be sampled in mono.
R-Mono:
The R channel of the bus specified by
Source Bus
will be sampled in mono.
Stereo:
The L and R channels of the bus specified by
Source
Bus
will be sampled in stereo. This will create a stereo
multisample and samples.
Sample Time
Specifies the amount of time that you wish to sample. This
can be set in 0.001 second increments. If you record a
sample in this condition (SAMPLING REC → START →
STOP), the change in time will be displayed automatically.
If
Save to
is set to Disk, the maximum value is calculated
from the amount of remaining space on the drive specified
by
Select Directory/File for Sample to Disk
. The
maximum sample time is 80 minutes.
When sampling to drive, bit resolution may also affect the
maximum sampling time. 24-bit data uses 50% more space
than 16-bit data.
Mode Page
SAMPLING SAMPLING > Recording
COMBINATION COMBINATION > Home– Sampling
PROGRAM PROGRAM > Home– Sampling
SEQUENCER SEQUENCER > Home– Sampling
Save to
Mode
Sample Time
Free Sample
Memory/
Locations
Save to
Sample Mode
Sample Time
Drive Select DoneOpen Up Play
To Next Page
Loading...
