Playing and editing Combinations
70
Saving your edits
Once you’ve tweaked the sound to perfection, you’ll want to
save your work. To save your edits:
1. Select the Write Combination command from the
page menu, at the upper right-hand corner of the
screen.
This brings up a dialog box which allows you to save the
Combination. Optionally, you can also select a new
location, or change the Combination’s name.
2. Press the Combination’s name to bring up the text
edit dialog.
You can give the Combination a descriptive name using
the on-screen keyboard.
After entering the name, press OK.
The text edit window will disappear, returning you to the
main Save dialog.
3. To set the category and sub-category, press the
“Category” and “Sub Category” pop-up buttons and
select the categories/sub-categories from the list.
4. Under “To” at the bottom of the dialog, press the
popup button next to Combination to bring up the
save location dialog.
Select a location to save the edited Combination.
You can write to any location in banks A–N. To avoid
overwriting the factory sounds, it’s safer to use a slot in
one of the empty User banks.
After selecting the location, press OK.
5. Press OK again to start the write process.
6. If you’re sure you want to write to this location, press
OK again.
After that, you’re done!
For more information, see “Writing Programs and
Combinations” on page 205.
Saving to media
You can also save and manage Combinations on the internal
drive and USB storage devices. For more information, see
“Saving to internal drive, CDs, and USB media” on
page 209.
To Next Page
Loading...
Need help?
General
