MIDI recording Recording MIDI in real-time
79
Recording MIDI in real-time
When you’ve finished with “Preparations for recording,” as
described above, you can start recording!
Real-time recording lets you record your performance on the
NAUTILUS, including the notes that you play, joystick and
knob movements, and so on. This is in contrast to step
recording, which is described in a later section.
The default is to record onto a single track at a time. As an
alternative, multitrack recording allows you to
simultaneously record multiple channels of data onto
multiple tracks. This is handy for use when recording RPPR,
ARP, or the Drum Track, or for recording the output of an
external sequencer in a single pass.
Recording setup
In Home– Recording Setup page, select the realtime
recording method you want to use.
Overwrite
With this method, the musical data previously recorded on a
track is overwritten by the newly recorded data. When you
perform overwrite recording on a previously-recorded track,
its musical data will be deleted and replaced by the newly
recorded data.
Normally you will use this method to record, and then
modify the results by using other types of realtime recording
or MIDI event editing.
1. Use “Track Select” to select the track that you want to
record.
2. Set the Recording Setup to Overwrite.
3. In “Location,” specify the location at which you wish
to begin recording.
4. Press the SEQUENCER REC button, and then press
the SEQUENCER START/STOP button.
If the
Metronome Setup
is still set to the default settings,
the metronome will sound for a two-measure pre-count,
and then recording will begin.
Play the keyboard and move controllers such as the
joystick to record your performance.
5. When you finish playing, press the SEQUENCER
START/STOP button.
Recording will end, and the location will return to the
point at which you begin recording.
To Next Page
Loading...
Need help?
General
