Appendices
240
Effects
Effects are not applied
Have you selected effect program 000?
• Select an effect other than 000: No Effect for
IFX1–12
,
MFX 1, 2
or
TFX 1, 2
.
Are the Effect Global SW
IFX 1–12 Off
,
MFX1&2 Off
, or
TFX1&2 Off
(GLOBAL > Basic Setup– Basic page)
settings checked?
If you are in COMBINATION or SEQUENCER mode and
master effects are not applied when you raise the
timbre/track
Send1
or
Send2
settings, does
Return 1
or
Return 2
from the master effect need to be raised?
Alternatively, have
Send 1
or
Send 2
for each oscillator of
the program used by the timbre/track been lowered?
Note:
The actual send level is determined by multiplying the
send setting of each oscillator in the program with the send
setting of the timbre/track.
Have you routed the output to an insert effect?
MIDI
The NAUTILUS does not respond at all to
incoming MIDI data
Are all MIDI cables connected correctly?
Is the MIDI data being received on the channel on which it is
being transmitted?
The NAUTILUS does not respond
correctly to incoming MIDI data
Are the GLOBAL > MIDI settings MIDI Filter
Enable
Program Change
,
Enable Bank Change
,
Enable Control
Change
,
Enable AfterTouch
, and
Enable Exclusive
each
checked?
Does the NAUTILUS support the types of messages that are
being sent to it?
Incorrect response to program change messages
Is the
Bank Map
setting correct?
The DYNAMICS knob does not respond to MIDI
input
The Dynamics function only works on notes that are played
using the keyboard of the NAUTILUS.
Dynamics has no effect on notes received via MIDI IN.
Internal drive, CDs, and USB Media
Internal drive and external USB devices
External USB devices are not recognized
Has the drive been formatted?
Is the external device connected correctly?
Have you waited a few seconds for newly-connected USB
devices to be recognized?
“Error in writing to medium” occurs frequently
when saving data
Use the page menu command
Check Medium
(MEDIA–
Utility page) to detect and repair errors on the media. For
more information, see “Check Medium” on page 731 of the
PG.
Save or Load operations cannot be completed
If there is no more room on the internal drive (the MEDIA
mode Media Info page’s
Free Space
parameter will show
zero free space), then Write, Save, or Load operations may
not be completed.
CD-R/RW (separately sold)
CD-R/RW drive is not recognized, or Can’t write
Was the drive subjected to physical shock or vibration while
data is being written?
If you are unable to save data such as PCG or SNG files, has
the disc been formatted?
Are you using the recommended media for your drive?
Are you using blank media?
• If using CD-R, please use new media.
Are you trying to use DVD media? The NAUTILUS cannot
write to DVD media.
A NAUTILUS CD-R/RW is not recognized by an
external device
A CD-R/RW saved or copied on the NAUTILUS using
packet writing is not recognized on a computer.
• If you install a UDF version 1.5 compatible UDF reader
or packet writing software on your computer, it will be
possible to recognize the disc.
To Next Page
Loading...
