Playing and editing Combinations
58
Easy Combination editing
Changing the Programs within a Combi
Changing the Programs assigned to the 16 Timbres is a
quick way to dramatically alter the sound of the
Combination.
Selecting Programs for Combi Tracks
To change the Program assigned to a Timbre:
1. Go to the COMBINATION > Home– Mixer page.
This page shows all 16 Timbres at once, including their
Program assignments, volume, pan, play/mute, solo, and
more.
2. Press Program Select of Timbre 1.
3. Select program using +, − buttons or VALUE dial.
Note that the new Program is now selected for Timbre 1.
4. Press Program Select of Timbre 1 again.
It brings up a window which lets you select Programs by
Category or, Bank–again, just like the similar window in
PROGRAM mode.
5. Select a different Program, and press OK.
The Program in the Timbre is now changed to the one
you just selected.
Adding a timbre
You can add timbres when selecting an InitCombi to make a
new combination, or when the combination is not using all
16 timbres.
1. Press an unused timbre (a timbre on which the “+”
button is displayed).
2. Change the program and each setting of the timbre
you added.
For timbres that have been added, the “Status” will be set
to “INT”, and “MIDI” will be set to “Gch”.
Note:
To disable a timbre, turn its “Status” to “Off” on
the COMBINATION > Home– Mixer– Status Play/Mute
page. (See “Status” on page 379 of the PG.)
Adjusting the mix
You can set the volume, pan, and EQ settings for each
Timbre.
Setting the volume and pan for each
Timbre
1. Go to the VOLUME tab on the COMBINATION >
Home– Mixer page.
This page shows the volume, pan, play/mute, solo, and
Program assignments for all 16 Timbres.
2. Select the on-screen Volume slider for Timbre 1.
3. Use the VALUE dial, or the numeric keypad
displayed by pressing the same number to set the
volume as desired.
4. Select the on-screen Pan knob for Timbre 1, and edit
its value as desired.
Timbre pan interacts with the pan stored in the Program. A
setting of
C064
reproduces the Program’s oscillator pan
settings. Adjusting the Timbre Pan will move the sound to
left or right while preserving the pan relationship between
the oscillators. A setting of
L001
is far left, and
R127
is far
right.
To Next Page
Loading...
Need help?
General
