Playing Songs Playback
75
Loop playback
When recording or playing back a song, you can individually
loop the MIDI tracks that are playing.
In the Home– MIDI Track Loop page, check
Track Play
Loop
for the MIDI tracks you want to loop, and use
Loop
Start Measure
and
Loop End Measure
to specify the
starting and ending measure of the region that will play back
as a loop.
If
Play Intro
is checked (enabled), the measures preceding
the loop will be played back as an introduction before the
loop begins.
If you play back from the first measure with the settings
shown in the screenshot below, the specified region of
measures will repeat as follows. Note that
Play Intro
is
enabled for Track 1, but disabled for Track 2.
If
Play Intro
is disabled (un-checked) for Track 1, the
specified region of measures will repeat as follows.
Measure12345678910111213
Track 1 1 2 3 4 5 6 7 8 5 6 7 8 5
Track 2 9109109109109109109
Measure12345678910111213
Track 1 5 6 7 8 5 6 7 8 5 6 7 8 5
Track 2 9 10 9 10 9 10 9 10 9 10 9 10 9
Loop Start
Measure
Track Play
Loop
Play Intro
Loop End
Measure
To Next Page
Loading...
