MIDI recording Recording the sound of a Combination or Program
85
Recording the sound of a Combination or Program
Here’s how you can easily copy the settings of a
Combination or Program, and then record using that sound.
Setup in SEQUENCER mode
(Copy From Combination and Copy From
Program)
In SEQUENCER mode, you can use the “Copy From
Combi” and “Copy From Program” page menu commands
to set up a Song based on a Combination or Program. In this
example, we’ll explain how to set up a song based on a
combination.
Note: Make sure that the global MIDI channel (GLOBAL >
MIDI– MIDI page, MIDI Channel) is set to 01.
1. Select a new, empty song.
2. Select the page menu command “Copy From Combi.”
A dialog box will appear.
Select the program or combination that you want to copy
(i.e., the copy source).
We will copy the effect settings of the combination as
well, so check the IFXs-All, MFXs and TFXs check
boxes.
Check Multi REC Standby. The Status will be
automatically set to REC for the MIDI tracks needed to
record that combination.
Press the OK button to execute the copy.
Notice that when you execute this command, the
Play/Rec/Mute setting of each track will be set
automatically. The Multi REC check box will be
checked.
3. Begin recording.
Press the LOCATE button to set the location to
001:01.000.
Press the SEQUENCER REC button, and then press the
SEQUENCER START/STOP button.
Note: If you play the keyboard during the pre-count
before recording, ARP and the Drum Track will start
playing the moment recording begins.
4. Record your performance.
5. When you are finished performing, press the
SEQUENCER START/STOP button.
If you made a mistake or want to re-record, you can use
the Compare function to re-record as many times as you
want.
To Next Page
Loading...
Need help?
General
