13
Initial Settings
1. When you finish making connections, set the
power switch to the “ON” position. (This set-
ting is referred to as Play mode.)
Use the ▲/▼ buttons to select a program.
2. Set the input level switch for the output level
of your guitar or bass.
Hi: High-output pickups (e.g., humbucking
pickups or pickups with a preamp)
Lo: Low-output pickups (e.g., single-coil
type pickups)
3. Set the volume control of your guitar or bass
to its usual position. Use the Value dial to
adjust the master level.
Quick Edit
In each mode (except when Mute/Bypass or Key
Lock are active), you can use the Amp Model-
ing selector to quickly change the amp model-
ing type, or use the control knobs to adjust the
gain, tone, or volume of amp modeling. When
you use the amp model selector to change the
amp model type, the cabinet type will automat-
ically change to the recommended type. When
you move a control knob, the parameter name
and value will appear for several seconds in the
value display. If the setting matches the original
setting, the ORIG icon will light.
The Delay Time can also be set by pressing
the TAP button twice at the desired interval (ex-
cept when in Rhythm & Bass mode). To check
the Delay Time that was specified, press and
hold the TAP button for two seconds or longer.
Program selection
Program name
Input level
switch
Amp selection
Amp gain, tone,
and volume
Program
number
Set the
delay time
Master level
adjustment
To Next Page
Loading...
Need help?
General
