25
1. Select the effect that you wish to edit
Each time you press the √/® buttons, you will
cycle through the effects in the order shown be-
low. When an effect is selected, its icon will blink.
2. Editing each effect
For each effect, you can select the effect type
and set its parameter values.
Effects that are turned “OFF” will automatically
be turned on if you press the ENTER/REC but-
ton or use the ▲/▼ buttons to select the effect
type.
For details on the effect types and parameters,
refer to Effect Parameters (p.30). Renaming the
program and writing the program are also per-
formed here.
1)DYNA
(Dynamics & Pickup Modeling)
These are dynamics-type effects such as com-
pressor and auto-wah that modify the tone, and
pickup modeling effects.
On,
Off
Parameter
value
Type selection
2)AMP (Amp Modeling)
The fifteen types BTQ CLN–FUZZ are guitar amps,
and the ten types VALVE–UKMAJOR are bass amps.
SYNTH is a synth for both guitar and bass.
*Operation will be different if SYNTH is
selected as the type.
Amount of distortion*
High range*Low range*
Volume*
On,
Off
Mid range*
Type selection
To Next Page
Loading...
Need help?
General
