19
key display
If “METRONM” – “METRO7”(metronome) is se-
lected as the rhythm pattern, there will be no
bass notes, and this screen will not appear.
When using Chain Patterns, the Bass Key set-
ting will be ignored.
4. Rhythm & Bass Reverb Level
Use the Value dial to set the amount of Reverb
for the Rhythm & Bass.
Reverb level
This uses the same reverb as the program ef-
fect. This parameter has no effect if you have
selected a program that does not use reverb
modeling, or if the reverb effect level is “0.”
5. Rhythm & Bass Level
Use the Value dial to set the level of Rhythm &
Bass sound. The bass note will be affected only
if Bass is turned on.
Rhythm & Bass
level
6. Chain Pattern settings
These parameters are added only if you select
“CHAIN” as the rhythm pattern. Press the EN-
TER/REC button to access the Chain Parame-
ter Select screen. Use the √/® buttons to se-
lect the location (1...16) for which you want to
change the pattern, and use the Value dial to
select the pattern (p.46) that will be used at that
location. Use the ▲/▼ buttons to specify the
bass key of the selected pattern.
To Next Page
Loading...
Need help?
General
