Reference Guide
140
For effects 40, 41, 42, 43 and 46, dynamic modulation (16C) can be used to control the DRY:EFF
balance.
Delay
LCD Parameter Range Description
17A
Delay Time (Time) 0–500 ms Delay time
Feedback (FB) –99…+99%
The amount of delay signal that is fed back into the effect.
Minus values invert the feedback signal phase
17B High Damp (H.Dmp) 0–99% High frequency decay
Hall, Room
LCD Parameter Range Description
17C
Reverb Time (Time)
0.2–9.9 sec (Hall)
The time over which the reverb effect will last
0.2–4.9 sec (Room)
High Damp (H.Dmp) 0–99%
High frequency decay
0 = bright reverb
99 = dark reverb
17D Pre Delay (P.Dly) 0–150 ms
The delay between the original sound and the early
reflections
Chorus
LCD Parameter Range Description
17C
Mod Depth (Mod) 0–99% Modulation depth
Mod Speed (M.SP) 0.03–30 Hz Modulation speed
17D Mod Waveform
Sine (SIN)
Triangle (TRI)
Modulation waveform
Flanger
LCD Parameter Range Description
17C
Mod Depth (Mod) 0–99% Modulation depth
Mod Speed (M.SP) 0.03–30 Hz Modulation speed
17D Feedback (FB) –99…+99%
The amount of effected signal that is fed back into the effect.
Minus values invert the feedback signal phase
Phaser
LCD Parameter Range Description
17C
Mod Depth (Mod) 0–99% Modulation depth
Mod Speed (M.SP) 0.03–30 Hz Modulation speed
17D Feedback (FB) –99…+99%
The amount of phased signal that is fed back into the effect.
Minus values invert the feedback signal phase
To Next Page
Loading...
