Reference Guide
157
Reference Guide
Global
Parameters
5
•
Note that the Global Channel and MIDI filter are also initialized.
PC/IF CLK and Page Memory are not initialized.
Source ALL : This allows all the data in PRE-a or PRE-b, Multi Setup data, and Global data to
be loaded.
Source CMB : This allows one of 100 Combinations of Preset a or b to be loaded into a specified
Combination number in the internal memory.
Source PRG : This allows one of 100 Programs of Preset a or b to be loaded into a specified
Program number in the internal memory.
Source KIT : This allows one of Drum Kits 1 and 2 of Preset a or b to be loaded to Drum Kit 1
or 2 in the internal memory.
•
If memory-protect is on for the Combinations, Programs, or Drum Kits, you cannot load the
corresponding data. Turn memory-protect off on page 3A and 3B.
•
Preset b data is the same as the sound data of X5 and 05R/W.
•
When you load data using Source CMB, Source PRG, or Source KIT, the X5DR may produce
Program sound that is different from the sound of Programs loaded using Source ALL.
This happens when the same Preset a or b data is not used for the Combination and its Timbre’s
Programs (and the Drum Kit if a Drum Program is being used), or when the load destination
Program number does not match the Timbre’s number. This also happens when a different
Drum Kit is used for the Drum Program Oscillator. Pay attention when you are loading sounds
individually.
To Next Page
Loading...
Need help?
General
