Koso RX2N GP - Trouble Shooting

5 -3 v>~ : The top speed test
, ~~---------".
The timer is automatic, so 0 km/h 3 km/h Speed up 180 km/h 179 km/h
when your bike start to ~ ®® ~hen the speed
th t
·
'11 t t ~ ~ ~ decreases,
move elmer WI s or the timer
to count the time and 0 0 0 0 will stop.
stop automatically after
you stops the bike. 0 M' '510 m
mIJ mIJ mIJ
BBBBEiB 088.9'B8 B[f3D8a
& During the test, the _will keep flashing!
When you
reach the top speed (180 km/h), the
meter will stop counting the distance (510 M),
fIJ"' .. • .. -~ •
.
l ' 'r- 1
and time (10"20 seconds).
\
'
,
.
I( you just want to use the (unction one time, hold down
• ~""!II~": -;'
~ ~-
•
'1[' the Select buffon (or 3 seconds to save the records and
~ back to the main screen.
If you want to test it again, press the Adjust
button to clear the record and enter the target
speed timer test screen again.
6 Trou ble sh~~JiJ] g
The following situation do not indicate malfunction of the meter.
Please
check the following before taking it in for repair .
.
Check item
The meter doesn't work when eThe power doesn't supply to the meter.
~Please make sure the wiring is
connected. The wiring and fuse are not
broken.
~ The battery is broken or the battery is toe
old to supply enough power DC 12V to
make the meter work.
ePlease check the voltage of your
battery, and make sure the voltage is
over DC12V.
ePlease make sure the speed sensor is
connected correctly
ePlease check the tire-size setting.
~please refer to the manual 4-1.
ePlease check the RPM sensor wiring is
connected correctly.
ePlease check the spark plug is R type
or not. If not, please replace the spark
plug with the R type spark plug.
ePlease check your setting.
~Please refer to the manual 4-2.
ePlease check your fuel tank.
~/s there any fuel inside?
ePlease check the wiring.
~Do you connect the wiring correctly?
ePlease check the setting.
~Please refer to the manual 4-9.
ePlease check the sensor.
~Does the wiring break or falling off?
eDo you connect the wiring correctly
~Please check the positive wire (Red)
connects to the battery, and main
switch positive wiring (Brown) connects
to the main switch.
the
power is on.
The meter shows wrong
information.
Speed does not appear or
appear incorrectly
Tachometer does not
appear or appear
incorrectly.
Fuel gauge does not
appear or appear
incorrectly
Temp does not appear or
appear incorrectly.
The clock is incorrect.
*If still can't solve the problems according to the steps above, please
contact with distributors or us.