Koso RX2N GP - 4-1 Speed Unit Setting; 4-2 Cycle; Piston Configuration

4 -1 Speed unit setting v:,l
In setting screen, press the Select button one
time to enter the speed unit setting.
Press the Adjust button to choose the speed unit.
EX. Now the setting is km / h.
6. Now the speed unit IS flashing! I
~ You could choose km /h or MPH in the
speed unit setting screen.
6. The odometer & trip meter will change
together with the speed unit.
Press the Select button to continue the function
setting.
~ When you leave this screen, the setting
is finIshed.
If you jusl wont to make this function settino. you could
4(' hOld (jown the Select button for 3 secondS to bock to
the mOin screen.
fl)
4-2 Cycle / piston setting
In setting screen, press the Select button 2 timE
to enter the stroke/ piston setting screen.
~~ - ~ ~ ~ ~
eM
ake sure the correct strokes and pistons before setting.
eMake sure the Input IS correct, or the RPM output will be incorrect.
eWe define the engine with the ignition system ignites every 360 degree c
2-stroke and the engine with the ignition system ignites every 720 degreE
as 4-stroke.
eSome 4-stroke bikes with one single piston are igniting every 360 degree
once, so the settIng should be the same as the bike with 2-stroke and
one piston engine.
Press the Adjust button to select the stroke.
EX. Now the stroke number is flashing.
6. Now the stroke setting number is flashIng!
~ You could set the stroke as 2 Cycle or 4
Cycle.
(ji) If you just wont to chec k your setting. you could hOld down
~ t he Select button for 3 seconds to bock to the main screer
Press the Select button to enter the piston settir
screen.
EX. Now the setting is changed from 2 Cycle to
Cycle.
Press the Adjust button to select the piston
number.
6. Now the piston number is flashing.
~ 2 Cycle: 1,2,3A pistons
4 Cycle:
1,2,3-4,5,6,8,10,12 pistons