BA 35203_04 * 3.0 * 35203_04_04_Inbetriebnahme_04.fm 4-57
Putting into operation 4
Important information on avoiding engine damage
Do not use additional starting aids (for example injection with start pilot).
In order to avoid damage to the starter, do not start the engine again
immediately after stopping it!
► Wait at least 10 seconds before starting again.
The vehicle is equipped with an automatic thermal overload protection for
motor oil and for driving and work hydraulics oil. The thermal overload
protection prevents the vehicle being put into operation in a cold state with
a high speed of the diesel engine.
- At temperatures below -10 °C (14 °F) , the maximum diesel engine
speed is automatically limited to 1500 rpm.
- At temperatures between -10 °C (14 °F) and +10 °C (50 °F), the
diesel engine idling speed is slightly increased until it reaches 10 °C
(50 °F).
- At temperatures over 10 °C (50 °F), the diesel engine can run without
any restriction.
At outside temperatures below −10°C (14°F), we recommend retrofitting
the machine with a fuel and/or engine and hydraulic oil preheater (option)!
The starter cannot be actuated if the engine is already running
(start repeat interlock).
If the diesel engine does not start, interrupt the start attempt after a max.
10 seconds so that the battery can recover.
► Repeat the start attempt only after about 1 minute.
To Next Page
Loading...
