4-58 BA 35203_04 * 3.0 * 35203_04_04_Inbetriebnahme_04.fm
4 Putting into operation
Starting the engine
Start the engine as follows
The preheating start switch 27 is located below the armrest.
1. Ensure that the parking brake (hand brake) is applied.
2. Turn the ignition key to position I.
➥ Indicator light check:
all indicator lights illuminate briefly.
The following warning and indicator lights remain illuminated:
• Control lamp 73 (parking brake applied)
• Control lamp 70 (motor oil)
• Control lamp 72 (generator charge function).
• Control lamp 71 (preheating); in cold outdoor temperatures until the
preheating temperature is achieved.
3. If the control lamp 71 goes out, turn the ignition switch key via the
position II in the position III and hold until the diesel engine runs.
4. Release the starting key.
5. Slowly increase engine speed.
6. Actuate the operating hydraulics and travelling drive only after all
indicator lights have gone out.
If one of the indicator lights 70 or 72 does not go out, stop the engine
immediately and have the cause checked by an authorized service centre!
Have a malfunctioning indicating instrument immediately replaced.
If the engine starts too early (indicator light 71 still illuminates), an error
message appears in the digital display.
► Switch off ignition and repeat the start procedure.
If the engine does not start after 30 seconds:
► Turn the ignition key back to position 0.
► Wait at least one minute before starting again.
The engine cannot be started by tow starting the machine, as there is
no driving connection between the engine and the gearbox (for example a
cardan shaft)! (Hydrostatic drive.)
Fig. 98
27
72
73
70
71
I
0
II
P
III
To Next Page
Loading...
