BA 35203_04 * 3.0 * 35203_04_05_Bedienung.fm 5-23
Operation 5
Parking the machine
Danger of accident when parking the machine on a gradient!
Serious injury or death can be caused by the machine rolling away.
► Apply the parking brake.
► In addition to the parking brake, secure the machine by placing chocks
(option) under the downhill sides of the wheels.
Engine damage by stopping the engine after full load.
► Let the engine run at idling speed for about 3 minutes so that the
temperature can stabilize, and then stop it.
1. Apply the parking brake – see “Parking brake” on page 5-16.
2. Switch off all additional control circuits – see “Additional front/rear
control circuit (option)” on page 5-44.
3. Lower the loader unit completely and set the bucket horizontally with
the ground. Operation – see “Control lever (joystick) overview” on
page 5-36.
4. Stop the engine and remove the starting key.
➥ The immobilizer (option) is enabled.
5. Close and lock the door and the windows.
6. Remove the key from the battery master switch
– see chapter 4 “Battery master switch (option)” on page 4-18.
7. Close the engine cover.
Additionally on slopes:
8. Take additional measures to secure the machine by placing chocks A
under the downhill sides of the wheels.
➥ The wheel chock is located on the left on the frame in front of the
cabin.
To Next Page
Loading...
