BA 35203_04 * 3.0 * 35203_04_05_Bedienung.fm 5-63
Operation 5
Removing an attachment from a SKID STEER quickhitch
The locked attachment is secured against unintentional actuation of
switch 82. It can only be unlocked from the quickhitch by means of the
two-hand controls.
The attachment can tip over after lowering it to the ground!
Can cause serious injury or death.
► Uncouple all flexible lines from the attachment.
► Lower the attachment on level ground and ensure it cannot tip over.
1. Empty the attachment and drive it to the drop-off position.
2. Set the attachment parallel to the ground. To do this, press the joystick
to the left A.
3. Lower the loader unit until the attachment is about 5 – 10 cm
(2 – 3.9 in) above the ground. To do this, push the joystick forward C.
In order to avoid damage to the attachment lock, follow the order of
unlocking.
4. Unlock the attachment. To do this, press and hold the touch button 50
in the position B.
5. Press the rocker switch 82 on the joystick to the right at the same time
until the lock pins fully come out of the center bores of the attachment.
6. Release switch 82 on the joystick.
7. Release push button 50.
8. Slightly tilt the attachment forward. To do this, press the joystick to the
right B.
9. Lower the loader unit. To do this: push the joystick forward C until the
attachment is on the ground without risk of falling over.
10.Reverse the machine away from the attachment.
If the attachment is placed in direct sunlight after having been taken off,
the oil in the hydraulic cylinders will warm up. This leads to a pressure
increase in the hydraulic cylinders that will make it difficult to attach the
hydraulic lines to the hydraulic connections.
► Set down the attachment out of the sun.
To Next Page
Loading...
