BA 35203_04 * 3.0 * 35203_04_05_Bedienung.fm 5-97
Operation 5
Safety instructions on transporting material
The load can tip backward if it is not secured and if the loader unit is
raised!
Can cause serious injury or death.
► Do not transport loads with a raised loader unit.
► Always tilt in the attachment a little toward the machine, carry it as
close as possible to the ground and bear in mind the required ground
clearance!
► After picking up the load, lower the loader unit to transport position and
tilt the pallet forks.
► Unload material only at machine standstill and do not tilt back the pallet
forks to the limit.
► Secure a bulky load before transporting it.
► Fit the rear of the pallet forks with a protection.
► Install a protective screen (option) onto the cabin.
► Use attachments with hydraulic grabs (option).
► Ensure good visibility of the material you want to pick up and of the
work and travel range.
The machine can tip over during machine travel or manoeuvres on
slopes with a load on the pallet forks!
Can cause serious injury or death.
► Lower the loader unit to transport position.
► If possible, travel in reverse with a load on the pallet forks.
The machine can tip over and the load can fall down in conditions of
strong wind and poor visibility with a raised loader unit and fully
loaded pallet forks!
Can cause serious injury or death.
► Avoid high storage positions for material that should not be exposed to
wind.
► Stop fork lift work in conditions of strong wind and poor visibility.
,
To Next Page
Loading...
