BA 35203_04 * 3.0 * 35203_04_05_Bedienung.fm 5-99
Operation 5
Fitting attachments from other manufacturers (option)
Quickhitches for attachments from other manufacturers
• The following quickhitch facilities can be purchased from your dealer
and installed by an authorized service center:
- Quickhitch for SKID STEER attachments
- Quickhitch for EURO attachments
- Quickhitch for VOLVO attachments
• Important!
Only approved attachments with an approved load diagram may
be used with the quickhitch facility
– see “Use of attachments on the machine” on page 3-11.
• If other attachments are used, conformity (stability test) in accordance
with the EC machine guideline or the EN 474-3 standard must be
checked and documented by an authorized service centre.
In the case of non-EU countries, follow and apply the national
regulations of these countries.
• Refer to the following information sheets on page 5-100 “Stability
calculations for attachments from other manufacturers” for the stability
test.
• Warranty and the operation license become void if non-approved
attachments are installed, or if parts of the quickhitch facility or
attachment (with a prescribed condition or quality, or the operation of
which can put persons at risk) are subsequently modified or replaced.
• In addition to the Operator’s Manual, observe and instruct the operator
in all other generally applicable, legal and other mandatory regulations
relevant to accident prevention and environmental protection.
Important information on fitting attachments from other manu-
facturers
Accident hazard if the attachments are not locked!
Can cause serious injury or death.
► Check whether lock pins E are visible on either side in the mounting
bores of the attachment.
Before connecting the hydraulics of the attachment from another
manufacturer to the 3rd control circuit, ensure that the pressure in the
quickhitch facility is released – see “Releasing the pressure at the plug
couplings” on page 5-66!
To Next Page
Loading...
