5-106 BA 35203_04 * 3.0 * 35203_04_05_Bedienung.fm
5 Operation
Load hook on loader unit tilt rod
Damage hazard to the lifting attachments and vehicle.
► Remove the attachment (bucket, pallet forks, etc.) from the quickhitch.
► Safely hitch the lifting gear (belts, cables, chains, etc.) on the load hook
above the quickhitch.
► Never place the lifting gear over sharp edges.
1. Hitch the lifting attachment in the mounts (lugs, straps) provided for
transporting the load.
2. Carefully raise the load and transport it near the ground.
➥ Do not exceed the load capacity, see load diagram A attached in
the cabin (front window) and Payload with load hook on tilt lever on
page 9-23 in this operator's manual.
Load hook on forks arms of pallet forks
Injury hazard when working with a load hook!
Observe the following precautionary measures in order to avoid a danger
of accident!
► Do not tilt the pallet forks in or out as you raise a load.
► Bear in mind the load diagram on the front window.
1. Set the fork arms of the pallet forks horizontally.
2. Put the load hook on the fork arms of the pallet forks.
3. Secure the load hook with safety pin A.
4. Carefully raise the load with lifting gear (belts, cables, chains, etc.) and
transport it close to the ground.
5. Do not exceed the load capacity, see load diagram B in the cabin (front
window).
To Next Page
Loading...
