BA 35203_04 * 3.0 * 35203_04_06_Transport.fm 6-5
Transport 6
Loading and tying down the machine
1. Secure the transport vehicle with chocks to prevent it from rolling.
2. Place the access ramps at the smallest possible angle.
➥ Do not exceed an angle of 20°.
➥ Use access ramps with an antiskid surface only.
3. Ensure that the loading area is clear and access to it is not obstructed,
for example by superstructures.
4. Ensure that the access ramps and the wheels of the machine are free
of oil, grease and ice.
5. Check the oil level of the diesel engine.
➥ The oil level must be visible at the MAX mark of the oil dipstick.
6. Start the machine.
7. Raise the loader unit enough so that it will not touch the access ramps.
8. Carefully drive the machine onto the middle of the transport vehicle.
9. Set the drive to neutral
– see chapter 5 “Neutral position, stopping the machine” on page 5-22.
10.Lower the loader unit to the loading area.
11.Stop the engine.
12.Apply the parking brake – see chapter 5 “Parking brake” on page 5-16.
13.Remove the starting key.
14.Do not allow anyone to stay in the cabin, lock the door and the engine
cover.
15.Ensure that the permissible maximum height of the transport vehicle is
not exceeded.
To Next Page
Loading...
