Kramer KIT-400

Kramer Electronics Ltd.
KIT-400 – Connecting KIT-400
9
Connecting KIT-400
Always switch off the power to each device before connecting it to your KIT-400. After
connecting your KIT-400, connect its power and then switch on the power to each device.
Figure 3: Connecting to the KIT-400
To connect KIT-400 as illustrated in the example in Figure 3:
1. Connect an HDMI source (for example, a Blu-ray player) to the IN 1 HDMI connector
on the KIT-400T front panel.
2. Connect an HDMI source (for example, a laptop) to the IN 2 HDMI connector on the
KIT-400T front panel.
3. Connect a computer graphics source (for example, a PC) to the IN 3 15-pin HD
connector and an unbalanced audio source (for example, the PC audio output) to the
AUDIO IN 3.5mm mini jack on the KIT-400T front panel.
4. Connect a control device to the LAN RJ-45 port on the KIT-400T rear panel.
5. Connect the HDBT OUT RJ-45 port on the KIT-400T to the HDBT INPUT RJ-45 port
on the KIT-400R.
6. Connect an HDMI source (for example, Kramer VIA GO) to the HDMI INPUT connector
on the KIT-400R.
7. Connect the HDMI OUTPUT connector on the KIT-400R to an HDMI acceptor (for
example, a display).
8. Connect the AUDIO OUTPUT 5-pin terminal block connector on the KIT-400R to a
balanced stereo audio source (for example, Kramer active speakers).
9. Connect the REMOTE TOGGLE switch to an occupancy sensor.
10. Connect the RELAY 3-pin terminal block connector to the room blinds.
11. Set POC switches on KIT-400T and KIT-400R to ON.
Failure to use PoC and power connector correctly may destroy the devices!
12. Connect the power adapter to one of the devices (KIT-400T or KIT-400R) and to the
mains electricity (not shown in Figure 3).
2
4
6
7
11
18
32
33
34
35
36
39
20
40