Kramer KIT-400

Kramer Electronics Ltd.
KIT-400 – Operating and Controlling KIT-400
12
Operating and Controlling KIT-400
Using Front Panel Buttons
Press the KIT-400T front panel buttons to select:
• The required input: IN 1 (HDMI) , IN 2 (HDMI) , IN 3 (VGA) or IN 4(REMOTE)
(HDMI on KIT-400R).
Press the KIT-400R front panel buttons to:
• Locally select the HDMI or HDBT inputs (when the SELECT button is not locked).
• Control device operation, using the MENU , ENTER (when in the OSD menu), +
and – ,buttons (see Using the OSD Menu on KIT-400R on page 16).
• Freeze the image on the output, using FREEZE button.
• Reset to XGA, using ENTER and FREEZE+ buttons.
• Reset to 1080p, using MENU and – buttons.
Using Remote Control Switches
The following table describes the function of the remote contact closure switches on KIT-400T
and KIT-400R .
Pin Name
Function
KIT-400T
KIT-400R
KIT-400T
SELECT
Short press – Select the input.
Long press – Adjust the VGA phase shift.
IN 4
Select the IN 4 input on KIT-400R.
VOL UP
Increase the analog audio output level.
Short press – Increase volume by one step.
Long Press – Increase the volume from 0 to
100% in 10 seconds.
VOL DN
Decrease the analog audio output level.
Short press – Decrease volume by one step.
Long Press – Decrease the volume from 100% to
0 in 10 seconds.
KIT-400R
TOGL
For connection to an occupancy sensor, or to a
single ON/OFF switch.
Configurable via the OSD for connection to a
button which toggles between display on and
display off (instead of using two separate buttons
for on and off), or turning the display on and off
according to whether a switch is open or closed
(for example, when using an occupancy sensor).
See Defining the TOGGLE PIN on KIT-400R
on page 22.
OFF
Turn off the display.
ON
Turn on the display.
1
3
5
8
23
26
27
29
28
14
36