Kramer KIT-400

Kramer Electronics Ltd.
KIT-400 – Connecting KIT-400
10
Connecting the Output to a Balanced/Unbalanced
Stereo Audio Acceptor
The following are the pinouts for connecting the output to a balanced or unbalanced stereo
audio acceptor:
Figure 4: Connecting to a Balanced Stereo Audio
Acceptor
Figure 5: Connecting to an Unbalanced Stereo Audio
Acceptor
Connecting to KIT-400 via RS-232
You can connect to the KIT-400 via an RS-232 connection using, for example, a PC.
KIT-400 features two RS-232 3-pin terminal block connectors:
• CONTROL - To control KIT-400 (for example, via a connected PC).
• CONTROL – To control KIT-400R (for example, via a connected PC).
• DATA ( for KIT-400T and KIT-400R) – To tunnel RS-232 data between the
transmitter and the receiver, see Tunneling RS-232 data between KIT-400T and
KIT-400R on page 13, (for example, to control the projector via RS-232 using a
controller at the transmitter side).
Connect the RS-232 terminal block on the rear panel of the KIT-400 to a PC/controller, as
follows:
From the RS-232 9-pin D-sub serial port connect:
• Pin 2 to the TX pin on the KIT-400 RS-232 terminal
block
• Pin 3 to the RX pin on the KIT-400 RS-232 terminal
block
• Pin 5 to the G pin on the KIT-400 RS-232 terminal
block
RS-232 Device KIT-400
12
37
13
38