Kramer KIT-400

Kramer Electronics Ltd.
KIT-400 – Using Embedded Webpages
30
KIT-400T webpages enable performing the following actions.
• Switching and adjusting Port Signals on page 30.
• Defining General settings on page 31.
• Configuring Network Settings on page 33.
• Defining Time and Date on page 35.
• Upgrading the Firmware on page 36.
• Setting Authentication on page 38.
• Defining Video and Audio Settings on page 40.
• Defining Receiver Settings on page 42.
• Configuring Device Automation on page 43.
• Managing EDID on page 59.
• Viewing About Page on page 64.
Switching and adjusting Port Signals
The Switching webpage enables performing the following functions:
• Selecting an Input Manually on page 30.
• Viewing the Audio Input Source on page 31.
• Adjusting the Audio Output Volume on page 31.
• Controlling Receiver Parameters on page 31.
Selecting an Input Manually
Select one of 4 inputs to switch to the output.
A green dot, on an input button, indicates that it is connected to an active source, as shown in
the example in Figure 17, for HDMI IN 2.
To select an input manually:
1. In the Navigation pane, click Switching. The Switching page appears (see Figure 17).
2. Click any of the following buttons:
▪ Local HDMI IN 1.
▪ Local HDMI IN 2.
▪ Local VGA IN 3.
When selecting the VGA input, adjust the phase of the VGA input sampling by
entering the value or using the slider.
▪ Remote HDMI IN 4.
The remote HDMI IN 4 input is located on the KIT-400R.
An input is selected.