Viewing the Audio Input Source
The audio input source is defined via DIP-switches 3 and 4 on the KIT-400T (see Setting
KIT-400T DIP-switches on page 13). You can view the input audio source in the Switching
page.
1. In the Navigation pane, click Switching. The Switching page appears (Figure 17).
2. View the input audio source according to DIP-switch setup.
The input audio source is viewed.
Adjusting the Audio Output Volume
KIT-400T enables adjusting the audio output volume via the embedded webpages.
To adjust the audio output volume:
1. In the Navigation pane, click Switching. The Switching page appears (Figure 17).
2. Do any of the following:
▪ Enter the audio volume value.
▪ Use the slider to set the volume.
▪ Click to mute the audio
Audio output volume is adjusted.
Controlling Receiver Parameters
Using the KIT-400T Switching webpage, you can control KIT-400R’s relay, and you can put
KIT-400R into standby mode or wake it from standby mode.
To control KIT-400R parameters:
1. In the Navigation pane, click Switching. The Switching page appears (Figure 17).
2. Do the following:
▪ Click ON or OFF to energize or release the relay.
▪ Click ON/OFF to put the device in standby mode or wake it from standby mode.
KIT-400R parameters are set.
Defining General settings
KIT-400T enables performing the following actions:
• Changing the device name (click Set to save the name).
• Defining Remote Buttons Functionality on page 32.
• Saving and Loading Settings on page 33.
• Performing a Factory Reset on page 33.
To Next Page
Loading...
