Kramer KIT-400

Kramer Electronics Ltd.
KIT-400 – Using Embedded Webpages
33
Saving and Loading Settings
KIT-400T enables you to save a configuration to recall it in the future.
Saving a Configuration
To save the current configuration:
1. Configure the device as required.
2. In the Navigation pane, click Device Settings. The Switching page opens (Figure 18).
3. Click Save. The Save File window appears.
When using Chrome, the file is automatically saved in the Downloads folder.
The current configuration is saved.
Loading a Configuration
To load a configuration:
1. In the navigation pane click Device Settings. The Switching page opens (Figure 18).
2. Click Upload. An Explorer window opens.
3. Select the required file and click Open.
The device is configured according to the saved preset.
Performing a Factory Reset
To reset the device to its factory default values:
1. In the Navigation pane, click Device Settings.
The Device Settings page appears (Figure 18).
2. Click Factory reset.
The following message appears. A communication warning message appears.
3. Click OK to start factory reset and follow the instructions on-screen.
The device resets to its default parameters.
Configuring Network Settings
KIT-400 enables you to configure network settings for your device.
For proper settings and before changing to DHCP, consult your Network administrator.