Kramer KIT-400

Kramer Electronics Ltd.
KIT-400 – Technical Specifications
68
Default Communication Parameters
RS-232
Baud Rate:
115,200
Data Bits:
8
Stop Bits:
1
Parity:
None
Command Format:
ASCII
Example (route video IN 2 to video HDBT OUT):
#ROUTE1,1,2<CR>
Ethernet
To reset the IP settings to the factory reset values go to: Menu->Setup -> Factory Reset-> press Enter to
confirm
IP Address:
192.168.1.39
Subnet mask:
255.255.0.0
Default gateway:
192.168.0.1
Default TCP Port #:
5000
Default UDP Port #:
50000
Default username:
Admin
Default password:
Admin
Full Factory Reset
Front panel:
There is no option for factory reset from front panel.
Protocol 3000:
“#factory” command.
Webpages:
Device Settings page, Soft Factory Reset resets all parameters to factory default except
for network parameters.
KIT-400R Output Resolution Support
KIT-400R supports the following resolutions.
640x480 @60Hz
1600x1200 @60Hz
3440x1440 @30Hz
1920x1080P @50Hz
800x600 @60Hz
1680x1050 @60Hz
3440x1440 @60Hz
1920x1080P @60Hz
1024x768 @60Hz
1920x1200 @60Hz RB
720x480P @60Hz
2560x1080P @50Hz
1280x768 @60Hz
2560x1600 @60Hz RB
720x576P @50Hz
2560x1080P @60Hz
1280x800 @60Hz
1920x1080 @60Hz
1280x720P @50Hz
3840x2160P @24Hz
1280x1024 @60Hz
1280x720 @60Hz
1280x720P @60Hz
3840x2160P @25Hz
1360x768 @60Hz
2048x1080 @50Hz
1920x1080P @24Hz
3840x2160P @30Hz
1400x1050 @60Hz
2048x1080 @60Hz
1920x1080P @25Hz
3840x2160P @50Hz
1440x900 @60Hz
2560x1440 @60Hz RB
1920x1080P @30Hz
3840x2160P @60Hz
Default EDID
This section includes the:
• KIT-400T Default EDID on page 69.
• KIT-400R Default EDID for HDMI on page 70.
• KIT-400R Default EDID for HDBT on page 72.