Controlling a Sink Device Connected to the Receiver
You can control a sink device via KIT-400T Maestro. To control the sink device via Maestro at
the transmitter, send a command via the RS232_HDBT port in Maestro.
For example, to turn the display off (DISPLAY OFF), send the #TUNNEL-CTRL
1,1,”TUNNEL-232 ‘DISPLAY OFF’9600”<CR> command from Maestro, via HDBT to the
KIT-400R.
Figure 11: Controlling a Sink Device on the Receiver via Maestro
Using the OSD Menu on KIT-400R
KIT-400R enables controlling and defining the device parameters via the OSD, using the front
panel MENU buttons.
To enter and use the OSD menu buttons:
1. Press MENU.
2. Press:
▪ ENTER to accept changes and to change the menu settings.
▪ Arrow buttons to move through the OSD menu, which is displayed on the video
output.
▪ EXIT to exit the menu.
To Next Page
Loading...
